SHP Series

SHP 2 & SHP 3 High Pressure Radiant Gas Brooders Home  » Poultry Animal Infrared Heaters » SHP Series » SHP2&3
SHP2
Ideal For Game Birds & Pigs
SHP3
Ideal For Game Birds Small Poultry & Pigs

Features

  • Stainless steel canopy adds extra strength – especially helpful if brooders are to be relocated.
  • Orifice Holder is easy to clean and wash down.
  • No electricity is required.
  • Stainless steel burner system modulates from low burn to high burn as needed for increased fuel efficiency.
  • Ideal Replacement For High Pressure Brooders
    SHP 2 & SHP 3 models are perfect replacements for other high pressure brooders. In most cases individual units can be replaced without added costs.
  • Reduces Fuel Consumption.
    Space-Ray high pressure radiant brooders save fuel by delivering radiant warmth directly to the ground level where it's needed most. Heating the ground level before the air saves fuel. Control Panel Options (see Specifications Tab below)
  • Non electric modulating
  • High/Low with integral digital thermostat
  • High/Low with remote thermostat
  • These models are for use with propane gas only
Model      BTU/Hr Input Min. Mounting Height Max. Mounting Height Ventilation Required Gas Consumption
SHP 2 4,200 BTU/Hr 20" 30" 18 CFM 0.046 GPH
SHP 3 7,000 BTU/Hr 24" 40" 28 CFM 0.076 GPH
Model    Control Suffix Gas Type Control Option Description
SHP 2 L6 Propane A manual valve with flame failure safety protection that is unregulated for use with an individual thermostat or a modulating or thermostatic control panel.
SHP 3 L6 Propane
Model    BTU/Hr Input Canopy Diameter Brooder Height Net Weight
SHP 2 4,200 BTU/Hr 8.5" 7" 2.2 lbs.
SHP 3 7,000 BTU/Hr 8.5" 7" 2.2 lbs.
Model    Gas Type Control Type Supply Pressure Min Supply Pressure Max. Voltage Amps
SHP 2 Propane #6 10" wc 4.5 psi N/A N/A
SHP 3 Propane #6 10" wc 4.5 psi N/A N/A

MINIMUM CLEARANCES TO COMBUSTIBLES

Model    Sides Ceiling Below
SHP 2 20" 20" 20"
SHP 3 20" 20" 20"

Note: All SHP 2's & SHP 3's include an Air Filter as Standard Equipment.

Space-Ray SHP Series
Thermostat & Control Panel Options

Thermostat Options
Space-Ray's SHP Series is available with two thermostat options. The Individual Thermostat Control provides easy and convenient ambient temperature control. The Remote Individual Thermostat Control (shown at far right) features a remote sensor that can be lowered to floor level for more precise reading of the temperature at liter level.

Individual Thermostat Control

4' Remote Sensor can be lowered closer to liter level for more precise reading of floor level temperature

Modulating Controllers

Space-Ray’s SHP Series, when combined with either one of Space-Ray’s economical High/Low control panels, can provide one of the highest fuel efficiencies of any brooder on the market today – dramatically increasing profits by reducing your cost of operation by up to 20%.

Non-Electric Modulating Controller, Part #44160000

The SHP17 modulating control panel requires no electricity for operation. It automatically controls the output level of the brooder based on the thermostat’s requirements.

Non-Electric Modulating Controller
click to enlarge
Hi/Lo Modulating Controller with EW-4-20 Thermostat, Part #44160050

Space-Ray’s unique High/Low control panels provide up to 20% lower fuel consumption by automatically adjusting the brooder’s output from maximum heat output to the minimum heat output in just second

Hi/Lo Modulating Controller with EW-4-20 Thermostat, Part #44160050
click to enlarge
Hi/Lo Modulating Controller with A419 Digital Electronic Thermostat, Part #44160100

Space-Ray’s unique High/Low control panels provide up to 20% lower fuel consumption by automatically adjusting the brooder’s output from maximum heat output to the minimum heat output in just seconds.

Hi/Lo Modulating Controller with A419 Digital Electronic Thermostat, Part #44160100
click to enlarge
Hose Kit – New Installation, Part #30522250

The hose kit is available for new installations using a ½” gas line that includes a ½” manual ball valve, ½” x ¼”bushing, ¼” close pipe nipple, quick disconnect socket, ¼” ID x 6’ hose with quick disconnect fitting, and an adaptor fitting to connect to the hose.

Hose Kit – New Installation, Part #30522250
click to enlarge
Hose Kit – Existing Installation, Part #30522260

The hose kit is for existing installations which includes the hose and adaptor fitting to connect the brooder. The hose has a quick disconnect fitting to connect to a Sturgis #104051 female quick disconnect fitting.

Hose Kit – Existing Installation, Part #30522260
click to enlarge